Hold Loops; The Hold Key - Hitachi SelecSet 900 User Manual

H L
OLD OOPS

Hold Loops

About hold
loops

The Hold Key

Using the hold
key
2-24
If your console is programmed with a hold loop, this is the
preferred way to hold a single call because hold loops do
not tie up CAPs. To hold a call using hold loops:
1 Press a hold loop (HLD1-HLD8) while on an active
call. The hold loop winks representing the held call.
2
Press the winking hold loop to retrieve the call.
Although you can use the <HOLD> key to place a single
call on hold, this is not recommended because the held
call occupies a CAP. You must use the <HOLD> key to
hold a conference.
To use the <HOLD> key:
1 Press the <HOLD> key while on an active call. A
CAP winks representing the held call.
2 Press the winking CAP to retrieve the call.
S S
ELEC
HCXTD860, Rev. A01, September 2001
940A U G
ET SER UIDE