Drive Bay Covers; Alignment Rails - Dell EMC ML3 User Manual

Figure 59. Drive bay covers
Note: A full-height tape drive must be installed in the lowest bay of the module.
2. Align and slowly insert the new tape drive into the drive bay along the alignment rails ( 1 in
Figure 60) while the drive assembly is supported. The tape drive must be flush with the back panel of
the library.
Figure 60. Alignment rails
3. Tighten the captive thumbscrews ( 1 in Figure 61 on page 108) with your fingers until the tape drive
is secure.
107
Upgrading and servicing