Removing The Ptt Unit (Et) - Yamaha 55DEHD Service Manual

Removing the PTT unit (ET)

1. Fully tilt the outboard motor up, and then
support it with the tilt stop lever 1.
1
w
9 When removing the PTT unit without
removing the power unit, be sure to sus-
pend the outboard motor. Otherwise, the
outboard motor could suddenly fall and
result in injury.
9 After tilting up the outboard motor, be
sure to support it with the tilt stop lever.
Otherwise, the outboard motor could
suddenly lower if the PTT unit should
lose fluid pressure.
NOTE:
If the PTT does not operate, turn the manual
valve 2 clockwise and tilt the outboard motor
up manually.
2. Disconnect the ground lead 3 at the bot-
tom of the PTT unit.
6885J11
3. Remove the tilt pin and 4 anode 5.
4. Remove the bracket bolts 6.
68830390
5. Remove the lock ties, and then pull out
2
6. Remove the cap and loosen the self-lock-
68870445
w
Do not remove the tilt stop lever 1 from
the clamp brackets.
Clamp bracket and swivel bracket
6
4
3
the PTT motor lead 7.
ing nut 8, then move the clamp brackets
slightly.
7
1
2
3
5
68870455
4
5
6
8
7
68870465
8
9
7-30