Adjusting The Trim Sensor Cam (Et) - Yamaha 55DEHD Service Manual

BRKT
5. Tighten the self-locking nut 8 to the
specified torque.
Self-locking nut 8:
15 N·m (1.5 kgf·m, 11.1 ft·lb)
6. Install the ground lead 9, anode 0 and
tilt pin q.
7. Pass the PTT motor lead w through the
hole of the port clamp bracket.
8. Fasten the PTT motor lead and trim sen-
sor lead with the lock ties e.
e
w
q
9
7-33
Bracket unit
8
68870490
0
68870500
9. Inject grease into all grease nipples until
grease comes out from the bushings a.
a

Adjusting the trim sensor cam (ET)

1. Fully tilt the outboard motor down.
2. Connect the test harness 1 to the trim
sensor coupler 2.
B
2
Gy
P
1
B
P
Gy
2 1
Test harness 1:
90890-06878
Digital circuit tester 3:
90890-03174
3. Measure the trim sensor resistance.
Trim sensor setting resistance:
Pink (P)–Black (B)
9–11 Ω
4. If the trim sensor resistance is out of
specification, adjust the trim sensor.
a
68830510
G
R
3
G
Br
R
B
68870520
6885J11