Epson PP-100II Technical Reference Manual page 89

List of Error Codes after Accepting Jobs
Handling of a job when an error occurs differs depending on the error type, The following explains about each error and the
remedies.
Cancel: The job is cancelled. After eliminating the cause of the error, issue the job again.
Pause: The job is temporarily stopped. After eliminating the cause of the error, restart the job using EPSON Total
Disc Monitor.
Automatic recover: The job is temporarily stopped. When the cause of the error is removed, the job is automatically resumed.
Job status Job handling
Accepted jobs Cancel
Chapter 4 Development Guide for a Cooperative Application
Error code
CAN000 Picking up a disc from the drive tray or the printer tray is failed.
Remedy:
Turn off Discproducer and turn it back on.
CAN001 A disc is dropped while being picked up.
Remedy:
(1) Turn Discproducer off and remove the dropped disc.
(2) Turn Discproducer back on.
CAN002 Releasing a disc is failed.
Remedy:
Turn off PP-100/PP-100N and turn it back on.
CAN003 Setting a disc in the drive tray or the printer tray must have been made, however, no disc is detected
in the tray.
Remedy:
(1) Turn Discproducer off and remove any foreign object inside the machine.
(2) Turn Discproducer back on.
CAN004 In Batch mode, the stacker 3 was not empty when the job was started. Therefore, the output stacker
has become full during processing the job.
Remedy:
(1) Remove all discs from the stacker 3.
(2) Put new blank discs into the stacker 1 and stacker 2, then restart the job.
CAN005 An error occurs while the robotic arm is moving.
Remedy:
(1) Turn Discproducer off and remove any foreign object inside the machine.
(2) Turn Discproducer back on.
CAN006 An auto loader fatal error has occurred. The robotic arm can not be moved due to overheating of
the motor.
Remedy:
(1) Turn Discproducer off and remove any foreign object inside the machine.
(2) Turn Discproducer back on.
CAN007 Controlling the drive tray is failed.
Remedy:
(1) Turn Discproducer off and remove any foreign object from the drive tray.
(2) Turn Discproducer back on.
CAN008 Processing the job is impossible because of a fatal error of the drive.
Remedy:
Turn off Discproducer and turn it back on.
Explanation and Remedies
4
89