Starting Td Bridge - Epson PP-100II Technical Reference Manual

Upgrade installation
You can install a new version of TD Bridge without uninstalling the current TD Bridge.
When upgrading the current TD Bridge, just follow the same procedure for normal installation.

Starting TD Bridge

When the installation is completed, start TD Bridge.
1
Click [Start]-[All Programs]-[EPSON TD Bridge]-[EPSON TD Bridge] to start TD Bridge.
When TD Bridge starts to run, its icon appears on the Task Tray.
Checks after starting TD Bridge
TD Bridge executes the following checks soon after it starts. If some problem is detected, an error message is displayed.
 Version check for EPSON Total Disc Maker
Checks the version of EPSON Total Disc Maker, and if it is not supported, the message is displayed accordingly. In such a
case, install EPSON Total Disc Maker Ver 6.0 or later again.
 Check for the default output equipment
Checks if the default output equipment on the environment settings is [enabled] or not. If it is set to [disabled], the
message is displayed accordingly. Configure the default output equipment on the environment settings. (See
Settings" on page 3-25
 Check the monitoring folder
Check if the monitoring folder is accessible or not. If not, the message is displayed accordingly.
If the system folder should be set as a monitoring folder, make sure to select a folder other than the system folder.
If the monitoring folder can not be found, set a monitoring folder on the environment settings again. (See
Settings" on page 3-25
24
TD Bridge executes various checkings when it starts. If some problem is detected, an error
indication is displayed, and TD Bridge closes itself. See "Checks after starting TD Bridge" for the
details.
for the environment settings.)
for environmental settings.)
TD Bridge
"TD Bridge
"TD Bridge