Suzuki SX4 2016 Owner's Manual page 175

OPERATING YOUR VEHICLE
the other hand, the driving mode does not
return to the LOCK mode automatically. You
should select the LOCK mode according to
the driving conditions.
NOTE:
• The information display shows current
driving mode.
• When the ignition switch is turned to the
"ON" position or the engine switch is
pressed to change the ignition mode to
"ON", the AUTO mode is selected auto-
matically.
• The driving mode switch can be oper-
ated when the vehicle is either stopped
or moving.
• Make sure that the front wheels are in
the straight ahead position when operat-
ing the driving mode switch.
• While making turns or accelerating and
decelerating, operating the driving mode
switch, turning the ignition switch to the
"ACC" or "LOCK" position or pressing
the engine switch to change the ignition
mode to "ACC" or "LOCK" may cause a
shock, but this is not a system malfunc-
tion.
• When you operate your vehicle under
conditions that involve wheel spin, such
as driving off-road in the sand or water
or when a wheel has run off the road, the
difference in the amount of revolution
between front wheels and rear wheels
increases (wheels run idle). If this state
continues, the oil temperature of the
driving system parts increases.
3-37
The 4WD warning light warns of this
condition by blinking. At the same time,
the information display shows this mes-
sage: "AWD SYSTEM HIGH TEMP
AWD IS OFF".
57L30042
When the 4WD warning light blinks, park
the vehicle at a safe place and run the
engine idle. After a while, the 4WD warn-
ing light will go out and the system will
resume.
NOTICE
• Note that 4WD vehicles are not all-
around vehicles. Be sure
observe the following instructions
when driving your vehicle.
– Do not drive through water such
as by crossing a river.
– Do not drive continuously in
places such as sand and mud
where front wheels tend to race.
– When any wheel is in the air for
such reason as running off the
road, do not race it needlessly.
(Continued)
NOTICE
(Continued)
• If the 4WD warning light comes on
or blinks when driving, there may
be something wrong with the four-
mode 4WD system. Have the sys-
tem inspected by an authorized
SUZUKI dealer.
NOTICE
Unevenly worn tires can cause prob-
lems with the 4WD system. Be sure to
rotate the tires according to the main-
tenance schedule. Refer to "Tires"
and "Maintenance Schedule" in the
"INSPECTION AND MAINTENANCE"
section for proper tire rotation proce-
dures.
to
Warning and Indicator Messages
The information display shows the warning
and indicator message when the four-
mode 4WD system is operated, or has a
problem.
83RM0-01E