Suzuki SX4 2016 Owner's Manual page 196

When you push the "CRUISE" switch (1),
the system is on and the cruise indicator
(5) will come on. When the vehicle's speed
is controlled by the cruise control system,
the set indicator (6) will come on.
Be careful of the following when operat-
ing with the cruise control
Even if your vehicle is equipped with the
radar brake support system, it cannot auto-
matically adjust to the speed of the vehicle
in front of you. Turn off the cruise control
system if you cannot operate safely at a
cruising speed.
Even in the following conditions, the set
indicator (6) will not disappear and the
cruising speed will not be canceled.
• When the forward collision warning is
working. If you depress the brake pedal,
the cruise speed will be canceled tempo-
rarily.
• When "RADAR BRAKE SUPPORT: NOT
ACTIVE BY SENSOR." message
appears and the radar brake support
system stops functioning. For safety pur-
poses, push the "CRUISE" switch (1) to
turn off the cruise indicator (5).
If the automatic brake system is working,
the cruise indicator (5) will turn off and the
cruise control system will be canceled.
Once you have determined that the condi-
tions are once again safe, reset the cruise
speed.
To Change Speed Temporarily
When the cruising speed is maintained,
you can temporarily accelerate or deceler-
ate.
To accelerate, depress the accelerator
pedal. When you take your foot off the
pedal, your vehicle will return to the set
speed.
To decelerate, depress the brake pedal.
The set speed will be canceled and the set
indicator (6) will go off.
To resume the previously set speed, push
the "RES +" switch (3) and turn on the set
indicator (6) again when vehicle speed is
above 40 km/h (25 mph). The vehicle will
accelerate to and maintain the previously
set speed.
NOTE:
For automatic transaxle or TCSS vehicle,
when the cruising speed is maintained,
you cannot decelerate by using the engine
brake even if you downshift from higher
gear to 3rd in the manual mode.
To decelerate while the cruise control is
on, depress the brake pedal or push the
"SET –" switch (4).
OPERATING YOUR VEHICLE
To Change Cruising Speed
Using the accelerator pedal
To reset at a faster cruising speed, accel-
erate to the desired speed using the accel-
erator pedal and push the "SET –" switch
(4). The new speed will be maintained.
Using the brake pedal
To reset at a slower cruising speed, decel-
erate to the desired speed using the brake
pedal and push the "SET –" switch (4). The
new speed will be maintained.
NOTE:
When the brake pedal is depressed, the
set indicator (6) goes off until reset the
cruising speed.
Using the "RES +" switch or the "SET –"
switch
To reset at a faster cruising speed, press
repeatedly or hold push the "RES +" switch
(3). Vehicle speed will steadily increase.
When you release the switch, the new
speed will be maintained.
To reset at a slower cruising speed, press
repeatedly or hold push the "SET –" switch
(4) until the vehicle has slowed to the
desired speed, then release the switch.
The new speed will be maintained.
NOTE:
You can adjust the set speed by approxi-
mately 1.6 km/h (1.0 mph) by pushing the
"RES +" switch (3) or the "SET –" switch
(4) quickly.
83RM0-01E
3-58