Eng A-Stop System - Suzuki SX4 2016 Owner's Manual

ENG A-STOP System

(Engine Auto Stop Start
System) (if equipped)
The ENG A-STOP system (Engine Auto
Stop Start System) automatically stops and
restarts the engine without operating the
ignition switch or the engine switch when
the vehicle is stopped, such as at a traffic
signal or in a traffic jam, to reduce exhaust
gases and fuel consumption.
• When the vehicle will be stopped for a
long time or when you will leave the
vehicle unattended, turn the ignition
switch to the "LOCK" position or press
the engine switch to stop the engine.
NOTE:
If your vehicle is equipped with the auto air
conditioning system, you can change the
auto engine stop condition via the informa-
tion display. Refer to "Information Display"
in the "BEFORE DRIVING" section.
72M2042
WARNING
• Do not go out the vehicle when the
engine is stopping by the ENG A-
STOP system. This may result in an
accident.
– For manual transaxle vehicle, if
the driver's seat belt is unfas-
tened and the driver's door is
opened, the engine will stall.
– For automatic transaxle or TCSS
vehicle, if the driver's seat belt is
unfastened even if the brake
pedal is pressed down, or the
driver's door is opened, the
engine will be restarted to warn
you that the engine was stopped
automatically by the ENG A-
STOP system.
(Continued)
OPERATING YOUR VEHICLE
WARNING
(Continued)
• When the engine does not restart
automatically even if you operate
properly, start the engine using the
ignition switch or engine switch.
– Keep stopping on the road may
result in rear collision.
– In case the vehicle moves, the
steering and braking operation
will require more efforts.
NOTICE
Only use the vehicle battery types
that have been approved by SUZUKI
vehicle manufacture, otherwise you
could damage your vehicle, and the
ENG A-STOP system could not be
available. If a vehicle battery has to
be replaced, consult your authorized
SUZUKI dealer.
The ENG A-STOP system is automatically
activated when the ignition switch is turned
to the "ON" position or the engine switch is
pressed to change the ignition mode to
"ON".
The system activation also requires the fol-
lowing conditions:
• Driver's seat belt is fastened.
• Driver's door is closed.
• Engine hood is closed.
83RM0-01E
3-42