Suzuki SX4 2016 Owner's Manual page 191

OPERATING YOUR VEHICLE
Changing Speed Temporarily
When the cruising speed is maintained,
you can temporarily accelerate or deceler-
ate.
To accelerate, depress the accelerator
pedal. When you take your foot off the
pedal, your vehicle will return to the set
speed.
To decelerate, depress the brake pedal.
The set speed will be canceled and "SET"
indicator (8) will disappear. To resume the
previously set speed, push "RES +" switch
(4) and turn on "SET" indicator (8) again
when vehicle speed is above about 40 km/
h (25 mph). The vehicle will accelerate to
the previously set speed and maintain its
speed.
Changing Cruising Speed
Using the accelerator pedal
To reset at a faster cruising speed, acceler-
ate to the desired speed using the accelera-
tor pedal and push "SET –" switch (5). The
new speed will be maintained.
Using the brake pedal
To reset at a slower cruising speed, decel-
erate to the desired speed using the brake
pedal and push "SET –" switch (5). The
new speed will be maintained.
3-53
NOTE:
When the brake pedal is depressed, "SET"
indicator (8) disappears until you reset the
cruising speed.
Using "RES +" switch or "SET –" switch
To reset at a faster cruising speed, press
repeatedly or hold push "RES +" switch
(4). Vehicle speed will steadily increase.
When you release the switch, the new
speed will be maintained.
To reset at a slower cruising speed, press
repeatedly or hold push "SET –" switch (5)
until the vehicle has slowed to the desired
speed, and then release the switch. The
new speed will be maintained.
NOTE:
• You can adjust the set speed by 1 km/h
(or 1 mph) by pushing "RES +" switch (4)
or "SET –" switch (5) quickly.
• You can adjust the set speed by 5 km/h
(or 5 mph) by pushing and holding "RES
+" switch (4) or "SET –" switch (5).
• While deceleration control or following
control is activated, the vehicle is not
accelerated even though resetting to
higher cruising speed by continuous
pushing "RES +" switch (4) is operated.
However, if the vehicle ahead disap-
pears, the vehicle is accelerated auto-
matically to the set speed.
Canceling Adaptive Cruise Control
"SET" indicator (8) will disappear and the
adaptive cruise control system will be can-
celed temporarily under the following con-
ditions:
Common:
• When "CANCEL" switch (3) is pushed
• When brake pedal is depressed
• When your vehicle speed falls below
about 40 km/h (25 mph)
• When your vehicle skids and ESP
activated
• When radar sensor is covered in snow,
water or dirt
• When engine speed is too high or too
low
• When driver's door is open
• When driver's seat belt is unfastened
• When parking brake is applied
• When "LIMIT" switch is pressed
®
• When ESP OFF switch is pressed
For manual transaxle vehicle:
• When clutch pedal is continuously
depressed
• When gear position is changed to "N"
(Neutral)
• When gear position is changed to 1st or
2nd
For automatic transaxle or TCSS vehicle:
• When gear position is changed from 3rd
to 2nd in the manual mode
83RM0-01E
®
is