Suzuki SX4 2016 Owner's Manual page 417

EMERGENCY SERVICE
sult a SUZUKI Dealer or a Roadside Assis-
tance Service.
NOTE:
If over inflated, deflate air by loosening the
screw of the filler hose.
7) Affix the speed restriction label from the
air compressor in the driver's field of
view.
8) Make a short drive immediately after
inflating to the required air pressure.
Drive carefully with a maximum speed
of 80 km/h (50 mph).
9) Carry on driving carefully to the nearest
SUZUKI Dealer or a tire repair shop.
WARNING
Do not affix the speed restriction
label to the air bag. Also do not affix
it to the warning light indicator or to
the speedometer.
10)After 10 km (6 mile) running, check the
tire pressure with the pressure gauge of
the compressor. If the air pressure is
indicated more than 220 kPa (2.2 bar),
the emergency repair is completed.
But, if the air pressure is indicated less
than the required air pressure, correct
the tire pressure to the required air
pressure. If the tire pressure has
dropped below 130 kPa (1.3 bar), the
Flat Tire Repair Kit cannot provide the
necessary seal. Do not drive on and
8-7
consult a SUZUKI Dealer or a Road-
side Assistance Service.
WARNING
Be sure to check the tire pressure
and confirm the completion of the
emergency repair after 10 km (6 mile)
of running.
NOTICE
Have the tire renewed at the nearest
SUZUKI Dealer. When repair to reuse
the sealed tire, consult a tire repair
shop.
The wheel can be reused after wiping
sealant off completely with cloth in
order not to rust, but the tire valve
and tire pressure monitoring system
(TPMS) sensor must be renewed.
Dispose of the sealant bottle at a
SUZUKI dealer or in accordance with
your regional codes and practices.
After using the sealant bottle, replace
it with a new bottle from your SUZUKI
dealer.
How to Use the Kit's Compressor to
Inflate a Tire
1) Place the vehicle on level, hard ground.
Set the parking brake firmly and shift
into "P" (Park) if your vehicle has a CVT
or TCSS, or shift into "R" (Reverse) if
your vehicle has a manual transaxle.
2) Take out the compressor.
3) Unscrew the valve cap from the tire
valve.
4) Connect the air hose of the compressor
to the tire valve.
5) Connect the power plug of the com-
pressor to the accessory socket. Start
the engine. Switch on the compressor.
Inflate the tire to the required air pres-
sure.
NOTICE
Do not operate the compressor for
longer than 10 minutes. It can cause
overheating of the compressor.
83RM0-01E