Mitsubishi Electric Melsec iQ-R Series User Manual page 117

CH1 Scaling lower limit value
Set a lower limit value for the range of the scale conversion.
For details on the scaling function, refer to the following.
Page 29 Scaling Function
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
CH Scaling lower limit value
■Setting range
• The setting range is from -32000 to 32000.
• In the channel where a set value does not satisfy the condition "the scaling upper limit value  the scaling lower limit value",
a scaling upper/lower limit value setting error (error code: 1A2H) occurs.
• In the channel where a value out of the setting range is set, a scaling setting range error (error code: 1A1H) occurs.
• When 'CH1 Scaling enable/disable setting' (Un\G504) is set to Disable (1), the setting of 'CH1 Scaling lower limit value'
(Un\G508) is ignored.
■Enabling the setting
Turn on and off 'Operating condition setting request' (Y9).
■Default value
The default value is 0 for all channels.
CH1 Warning output setting (Process alarm)
Set whether to enable or disable the warning output of a process alarm.
For details on the warning output function (process alarm), refer to the following.
Page 32 Process alarm
Setting value
0
1
If a value other than the above is set, a warning output setting (Process alarm) range error (error code: 1B0H) occurs.
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
CH Warning output setting (Process alarm)
■Enabling the setting
Turn on and off 'Operating condition setting request' (Y9).
■Default value
The default value is Disable (1) for all channels.
CH1 CH2 CH3 CH4
508 708 908 1108
Setting details
Enable
Disable
CH1 CH2 CH3 CH4
512 712 912 1112
CH5 CH6 CH7 CH8
1308 1508 1708 1908
CH5 CH6 CH7 CH8
1312 1512 1712 1912
APPX
Appendix 3 Buffer Memory Areas
A
115