Appendix 3 Buffer Memory Areas; List Of Buffer Memory Addresses - Mitsubishi Electric Melsec iQ-R Series User Manual

Appendix 3

List of buffer memory addresses

This section shows the lists of buffer memory addresses of the A/D converter module. For details on the buffer memory, refer
to the following.
Page 104 Details of buffer memory addresses
The buffer memory areas of the A/D converter module are classified by the following data types.
Data type Description
Setting data Description
Write/read attribute
Setting method
Setting timing
Control data Description
Write/read attribute
Setting method
Setting timing
Monitor data Description
Write/read attribute
Setting method
Setting timing
Do not write data to the system areas and areas whose data types are monitor in the buffer memory. Writing
data into these areas can cause the malfunction of the module.
Buffer Memory Areas
Set this data according to the connected device and the application of the system.
Data can be read and written from/to this area.
Set this data using an engineering tool or a program.
After changing values, turn on and off 'Operating condition setting request flag' (Y9) to enable the
set values.
Use this data to control the A/D converter module.
Data can be read and written from/to this area.
Set this data using an engineering tool or a program.
As soon as values are changed, the set values are enabled.
Use this data to monitor the status of the A/D converter module.
Reading data is only allowed. Writing data is not allowed.


APPX

Appendix 3 Buffer Memory Areas

A
95