3
CommDTM
This chapter describes CommDTM (M_CommDTM-HART) that can be used for A/D converter module.
HART-enabled device parameters can be read and written via an A/D converter module using M_CommDTM-HART in the
FDT frame application.
In this manual, MELSOFT FieldDeviceConfigurator (FDC) manufactured by Mitsubishi Electric is used as the
FDT frame application. For details on FDC, refer to the following.
FieldDeviceConfigurator Operating Manual
3.1
Required Software
To configure the HART-enabled device settings using M_CommDTM-HART, the following software needs to be installed in
advance.
FDT frame application
M_CommDTM-HART can be used only in the FDT frame application. Install the FDT frame application in advance that meets
the specifications described in the manual below.
CommDTM for R60ADI8-HA Installation Instructions (BCN-P5999-1049)
Device DTM of HART-enabled device to be used
Install in advance Device DTM of a HART-enabled device to be connected to the A/D converter module. For specifications
and how to obtain Device DTM, contact the manufacturer of the used HART-enabled device.
3.2
How to Install/Uninstall M_CommDTM-HART
For installation and uninstallation procedures of M_CommDTM-HART, refer to the following.
CommDTM for R60ADI8-HA Installation Instructions (BCN-P5999-1049)
3 CommDTM
59
3.1 Required Software
3