Mitsubishi Electric Melsec iQ-R Series User Manual page 96

Operating condition setting request
Turn on and off 'Operating condition setting request' (Y9) to enable the setting of the A/D converter module.
For the timing of turning on and off the signal, refer to the following.
Page 90 Operating condition setting completed flag
For details on the buffer memory areas to be enabled, refer to the following.
Page 95 List of buffer memory addresses
■Device number
The following shows the device number of this output signal.
Signal name
Operating condition setting request
Maximum value/minimum value reset request
Turn on and off 'Maximum value/minimum value reset request' (YD) to clear the maximum and minimum values stored in 'CH1
Maximum value' (Un\G404) and 'CH1 Minimum value' (Un\G406).
For the timing of turning on and off the signal, refer to the following.
Page 92 Maximum value/minimum value reset completed flag
■Device number
The following shows the device number of this output signal.
Signal name
Maximum value/minimum value reset request
Error clear request
Turn on and off 'Error clear request' (YF) to clear 'Error flag' (XF), 'Input signal error detection signal' (XC), 'Latest error code'
(Un\G0), and 'Latest alarm code' (Un\G2). For the timing of turning on and off the signal, refer to the following.
Page 91 Input signal error detection signal
Page 92 Error flag
■Device number
The following shows the device number of this output signal.
Signal name
Error clear request
APPX
94
Appendix 2 I/O Signals
CH1 CH2 CH3
Y9
CH1 CH2 CH3
YD
CH1 CH2 CH3
YF
CH4 CH5 CH6
CH4 CH5 CH6
CH4 CH5 CH6
CH7 CH8
CH7 CH8
CH7 CH8