Device Dtm Settings - Mitsubishi Electric Melsec iQ-R Series User Manual

3.5

Device DTM Settings

Set Device DTM of the HART-enabled device. The Device DTM setting details are written to a HART-enabled device via the
destination A/D converter module set in M_CommDTM-HART.
The Device DTM setting details and how to write the settings to a HART-enabled device differ depending on
the used Device DTM. For details, refer to the manual or help of the used Device DTM.
1.
Perform wiring for the A/D converter module and the HART-enabled device.
2.
Right-click on "M_CommDTM-HART" of MyNetwork to select "Add DTM/Block".
3.
Select the target Device DTM from the displayed DTM catalog and click [OK].
4.
Select a channel connected to the HART-enabled device and click [OK].
5.
Connect a personal computer and the HART-enabled device online.
[MyNetwork]  [M_CommDTM-HART]  Right-click  [Online]
The following message appears when the HART-enabled device is not properly connected.
6.
Set a parameter of the target HART-enabled device from Device DTM added to the project view.
7.
Write a parameter from the Device DTM window to the HART-enabled device.
3 CommDTM
70
3.5 Device DTM Settings