Brother MFC Series Service Manual page 45

First Line
Image too Long
Image too Short
Ink Absorber Full
/Ink Box Full
Install Starter Ink
Low Temperature
No Caller ID
No Ink Cartridge
No Paper Fed
No Response/Busy
Out of Fax Memory
Out of Memory
Paper Jam
Touchscreen Init.
Failed
Unable to Print
Status
The image cannot be corrected because it is
too large.
The image cannot be trimmed because it is
too small.
The purge count or flushing count reached
the upper threshold.
A cartridge without the necessary ink volume
for initialization was loaded during
initialization.
The Casing internal thermistor detected that
the room temperature is too low.
There is no Caller ID information.
No Ink cartridge loaded.
The Registration sensor detected that there
is no recording paper in Paper tray.
The receiver is busy or there was no
response.
The amount of accumulated data in the
memory through Memory Receive exceeded
the limit.
There is not enough memory.
The Registration sensor, Paper width sensor,
and CR encoder sensor detected a paper
jam.
After the power was turned on, the screen
was touched before Touch panel initialization
could be completed.
Some problem occurred during printing.
2-13
Error
Reference
Code
Section
4.7.5
Section
4.7.5
46 2-31
24 2-20
Section
4.9.3
2A, 2B, 2-22
2C, 2D
Section
4.2.1
Section
4.9.3
Section
4.10.2
Section
4.10.2
31, 38, 2-25,
3C, 82, 2-26,
84, 8A, 2-27,
8C 2-37,
2-38,
2-39
ED 2-44
Take
action
according
to the
displayed
error
code.
Confidential