ABB Endura AZ40 Manual page 31

Operation modes
The transmitter has 4 modes of operation – all modes are
accessed from the Operator menu – see Fig. 25:
— Operating – displays real-time process values on Operating
Pages (refer to Section , page 32).
— View – displays diagnostic messages, alarms, output values,
signals and (chart) traces (refer to Section , page 33).
— Log – displays recorded diagnostic, calibration and audit
events and alarms (refer to Operating instruction
OI/AZ40-EN).
— Configuration – enables the transmitter to be configured
(refer to page 21).
Operator menus
IMPORTANT (NOTE)
Operator menus cannot be accessed directly from the
Configuration level.
Referring to Fig. 25, Operator menus
Operating, View or Log page by pressing the
To select Operator sub-menus (indicated by the
C
the key .
D
CAL shortcut – opens the Calibrate page directly from an
Operator Page, bypassing the Configuration level menus. Press
C
the key (below the CAL prompt).
Data Views
Logs
Alarm Acknowledge
Autoscroll
In Conf Alarm
Enter Configuration
A
B
Fig. 25 Operator menus
CI/AZ40-EN Rev. A
A
are accessed from any
B
key .
arrow), press
CAL
D
C
Operator menus comprise:
— Operator Pages – displays Operator Pages1 to 5 –
see page 32.
— Data Views – displays enabled data views.
— Logs – displays enabled Log views.
— Alarm Acknowledge – acknowledges the active alarm
displayed in the Alarms View.
— Media Card – displays the status of the SD Card (enabled
only if a removable media module is fitted) and enables the
operator to place the media online / offline.
— Autoscroll (enabled on Operator pages only) – displays
Operator pages 2 to 5 sequentially.
— Enter Configuration (enabled on all pages) – enters
Configuration parameters via the Access Level. Refer to
Operating instruction OI/AZ40-EN for access levels and
password security options.
31