Selecting And Changing Parameters - ABB 2600T Series Operating Instruction

Calling up the error description
Additional details about the error that has occurred can be
called up on the information level.
Process display
Electronics
1. Use to go to the information level.
Operator Menu
Diagnostic
Operator Page 1
Signals View
Back Select
2. Use or select the submenu "Diagnostic".
3. Confirm the selection with
Electronics
- F123.321 -
Kurzbeschreibung
Hinweise
Back
The first line shows the area in which the error has occurred.
The second line shows the unique error number.
The next lines show a brief description of the error and
information on how to remedy it.
IMPORTANT (NOTICE)
For a detailed description of the errors and fault
correction instructions, please refer to Chapter 12
"Error messages".
Switching to the configuration level (parameterization)
The device parameters can be displayed and changed on the
configuration level.
Process display
1. Change to the configuration level with
.
Exit
.

11.5.4 Selecting and changing parameters

Entry from table
When an entry is made from a table, a value is selected from a
list of parameter values.
Menu name
Parameter name
Currently set value
Next
1. Select the parameters you want to set in the menu.
2. Use to call up the list of available parameter values.
The parameter value that is currently set is highlighted.
Parameter name
Parameter 1
Parameter 2
Parameter 3
Cancel
3. Use or to select the desired value.
4. Confirm the selection with
This concludes the procedure for selecting a parameter value.
Numerical entry
When a numerical entry is made, a value is set by entering the
individual decimal positions.
Menu name
Parameter name
12.3456 [unit]
Next
1. Select the parameters you want to set in the menu.
2. Use to call up the parameter for editing. The decimal
place that is currently selected is highlighted.
266CRx, 266JRx, 266CSx, 266JSx | OI/266CXX/266JXX/HART-EN Rev. B 41
Edit
OK
.
Edit