Plates And Symbols; Safety / Warning Symbols, Note Symbols; Compliance With Pressure Equipment Directive (2014/68/Eu); Transport - ABB 2600T Series Operating Instruction

3.6

Plates and symbols

3.6.1

Safety / warning symbols, note symbols

DANGER – Serious damage to health / risk to
life
This symbol in conjunction with the signal word
"DANGER" indicates an imminent danger. Failure
to observe this safety information will result in
death or severe injury.
DANGER – Serious damage to health / risk to
life
This symbol in conjunction with the signal word
"DANGER" indicates an imminent electrical
hazard. Failure to observe this safety information
will result in death or severe injury.
WARNING – Bodily injury
This symbol in conjunction with the signal word
"WARNING" indicates a potentially dangerous
situation. Failure to observe this safety
information may result in death or severe injury.
WARNING – Bodily injury
This symbol in conjunction with the signal word
"WARNING" indicates a potential electrical
hazard. Failure to observe this safety information
may result in death or severe injury.
CAUTION – Minor injuries
This symbol in conjunction with the signal word
"CAUTION" indicates a potentially dangerous
situation. Failure to observe this safety
information may result in minor or moderate
injury. The symbol may also be used for property
damage warnings.
NOTICE – Property damage
This symbol indicates a potentially damaging
situation.
Failure to observe this safety information may
result in damage to or destruction of the product
and / or other system components.
IMPORTANT (NOTE)
This symbol indicates operator tips, particularly
useful information, or important information about
the product or its further uses. The signal word
"IMPORTANT (NOTE)" does not indicate a
dangerous or harmful situation.
3.7 Compliance with Pressure Equipment Directive
(2014/68/EU)
Devices with PS > 200 bar (20 MPa)
Devices with a permissible pressure of PS > 200 bar (20 MPa)
have been tested for conformity by the Technical Supervisory
Association TÜV NORD (0045) in accordance with module H
and can be used for liquids of group 1 (PED: 1G).
The rating plate contains the following designations: PED: 1G.
Devices with PS ≤ 200 bar (20 MPa)
Devices with a permissible pressure PS ≤ 200 bar (20 MPa)
conform to sec. 3 para. (3) and have not been tested for
conformity. The devices have been constructed and
manufactured according to sound engineering practice (SEP).
The CE mark on the device does not apply for the Pressure
Equipment Directive.
The rating plate then contains the following identification
codes: PED: SEP.
3.8

Transport

After final calibration, the device is packed in a carton to
provide protection against physical damage.
3.9

Transport safety instructions

Observe the following instructions:
— Do not expose the device to humidity during transport.
Pack the device accordingly.
— Pack the device so that it is protected against vibrations
during transport, e.g., by using air-cushioned packaging.
Prior to installation, check the devices for possible damage
that may have occurred as a result of improper transport.
Details of any damage that has occurred in transit must be
recorded on the transport documents. All claims for damages
must be submitted to the shipper without delay and before
installation.

3.10 Obligations of the owner

Prior to using the devices with corrosive or abrasive media,
the owner must check the level of resistance of all parts that
come into contact with the process liquid.
ABB would be pleased to provide support in the selection of
suitable materials, however we can assume no liability
whatsoever.
266CRx, 266JRx, 266CSx, 266JSx | OI/266CXX/266JXX/HART-EN Rev. B 7