Contents; Storage Conditions; Safety Instructions For Electrical Installation; Safety Instructions For Operation - ABB 2600T Series Operating Instruction

3.11 Storage conditions

— The device must be stored in dry and dust-free conditions.
Always keep the device in its original package during
storage / transport.
— Observe the permissible ambient conditions for transport
and storage according to the chapter "Technical Data".
— In principle, the devices may be stored for an unlimited
period. However, the warranty conditions stipulated in the
order confirmation of the supplier apply.

3.12 Safety instructions for electrical installation

The electrical connection may only be established by
authorized specialist personnel and in accordance with the
connection diagrams.
The electrical connection information in this manual must be
observed; otherwise, the IP rating may be adversely affected.
Ground the measurement system according to requirements.

3.13 Safety instructions for operation

Before switching on the device, make sure that your
installation complies with the environmental conditions listed in
the chapter "Technical Data" or on the data sheet.
If there is a chance that safe operation is no longer possible,
take the device out of operation and secure it against
unintended startup.
3.14 Safety information for inspection and maintenance
WARNING – Electrical dangers!
When the housing is open, EMC protection is
impaired and there is no longer any protection
against accidental contact.
Switch off the power supply before opening the
housing.
Corrective maintenance work may only be performed by
trained personnel.
— Before removing the device, depressurize it and any
adjacent lines or containers.
— Check whether hazardous materials have been used as
materials to be measured before opening the device.
Residual amounts of hazardous material may still be
present in the device and could escape when it is opened.
Within the scope of operator responsibility, check the following
as part of a regular inspection:
— the pressure-carrying walls / lining of the pressure device
— the measurement-related function
— the leak tightness
— the wear (corrosion)
8 OI/266CXX/266JXX/HART-EN Rev. B | 266CRx, 266JRx, 266CSx, 266JSx

3.15 Returning devices

Use the original packaging or a secure transport container of
an appropriate type if you need to return the device for repair
or recalibration purposes. Fill out the return form (see the
Appendix) and include this with the device.
According to the EU Directive governing hazardous materials,
the owner of hazardous waste is responsible for its disposal or
must observe the following regulations for shipping purposes:
All devices delivered to ABB must be free from any hazardous
materials (acids, alkalis, solvents, etc.).
Please contact Customer Center Service acc. to page 2 for
nearest service location.

3.16 Integrated management system

ABB Automation Products GmbH operates an integrated
management system, consisting of:
— Quality management system to ISO 9001:2008
— Environmental management system to ISO 14001:2004
— Occupational health and safety management system to
BS OHSAS 18001:2007 and
— Data and information protection management system
Environmental awareness is an important part of our company
policy.
Our products and solutions are intended to have minimum
impact on the environment and on people during
manufacturing, storage, transport, use, and disposal.
This includes the environmentally-friendly use of natural
resources. We conduct an open dialog with the public through
our publications.