Siemens Sinumerik 802D sl Programming Manual page 202

Machine and Setting Data
D.1 Machine/Setting Data
10715
MD number
Default setting: - -1
Changes effective after Power On
Data type: DWORD
Meaning:
D-202
M_NO_FCT_CYCLE[0]
M function number for cycle call
Minimum input limit: - -1
Protection level: 2/7
M number with which a subprogram is called.
The name of the subprogram is stored in $MN_M_NO_FCT_CYCLE_NAME. If the M func-
tion defined by $MN_M_NO_FCT_CYCLE is programmed in a part program, the subpro-
gram defined in M_NO_FCT_CYCLE_NAME is started at the end of the block. If the M
function is programmed again in the subprogram, the substitution no longer takes place by
means of a subprogram call.
$MN_M_NO_FCT_CYCLE is effective both in Siemens mode G290 and in external lan- -
guage mode G291.
A subprogram call may not be superimposed on M functions with fixed meanings.
In the event of a conflict, alarm 4150 is output:
- - M0 to M5,
- - M17, M30,
- - M40 to M45,
- - M function for spindle/axis mode switchover according to
$MC_SPIND_RIGID_TAPPING_M_NR (default M70)
- - M functions for nibbling/punching according to configuration via
$MC_NIBBLE_PUNCH_CODE if activated via
$MC_PUNCHNIB_ACTIVATION.
- - With applied external language ($MN_MM_EXTERN_LANGUAGE) M19, M96- -M99.
Exception: The M functions defined for the tool change with
$MC_TOOL_CHANGE_M_CODE.
$MN_M_NO_FCT_CYCLE_NAME and $MN_T_NO_FCT_CYCLE_NAME may not be
active in the same block (part program line), i.e. only one M/T function substitution can be
active per block. Neither an M98 call nor a modal subprogram call can be programmed in
the block with the M function substitution. A subprogram return jump or end of part program
is not allowed.
Alarm 14016 is output in the event of a conflict.
SINUMERIK 802D sl/840D sl840D/840Di sl/840Di/810D ISO Turning - - 04.07 Edition
Maximum input limit: - -
Unit: - -
Applies with effect from SW version: 5.2
© SIEMENS AG 2007 All rights reserved
04.07