Tool Retract (G10.6) - Siemens Sinumerik 802D sl Programming Manual

04.07
2.4

Tool retract (G10.6)

To replace the tool damaged during machining or to check the status of machining,
the tool can be withdrawn from a workpiece. In fact, a machine specific sequence
can be initiated. Therefore, please refer to the machine tool builders documentation
for details.
Format
G10.6 X... Z... ; Activation
G10.6 ; Deactivation
X, Z :
In incremental mode, retraction distance from the position where the retract signal
is turned on. In the absolute mode, retraction distance to an absolute position.
Warning
!
The retraction axis and retraction distance specified in G10.6 need to be changed
in an appropriate block according to the figure being machined. Be very careful
when specifying the retraction distance;
An incorrect retraction distance may damage the workpiece, machine, or tool.
© SIEMENS AG 2007 All rights reserved
SINUMERIK 802D sl/840D sl840D/840Di sl/840Di/810D ISO Turning -- 04.07 Edition
Commands Calling Axis Movements
2.4 Tool retract (G10.6)
2-53