Instantaneous Mapping Of The Iso Functions Onto The Siemens Frames; (Until Powerline 7.04.2, Solution Line 1.4) - Siemens Sinumerik 802D sl Programming Manual

04.07
3.1.5 Instantaneous mapping of the ISO functions onto the Siemens
frames

(until powerline 7.04.2, solution line 1.4)

By changing an external workpiece zero point offset value or workpiece zero point
offset value, the workpiece coordinate systems determined through G54 to G59 as
well as G54 P{1 ... 100} are changed.
In order to change an external workpiece zero point offset value or workpiece zero
point offset value, two methods are available.
1. Entering data using the HMI panel
2. By program command G10 or G92
Fig. 3-3
© SIEMENS AG 2007 All rights reserved
SINUMERIK 802D sl/840D sl840D/840Di sl/840Di/810D ISO Turning - - 04.07 Edition
Channelspecific Basic Frames
$P_CHBFRAME[3]
$P_CHBFRAME[2]
$P_CHBFRAME[1]
$P_CHBFRAME[0]
$P_CHBFRAME[0]
ISO-dialect coordinate systems
Movement Control Commands
3.1 The coordinate system
progr. Frame
$P_BFRAME
adjustable Frame G54 - G59 NV
$P_UIFR G54 P1..100 NV
G68 3DRot
G68 2DRot / 3DRot
G51.1 Mirror image at progr. axis
G92 set value
EXOFS
G52 NV
G51 scale
3-59