Siemens Sinumerik 802D sl Programming Manual page 211

04.07
10890
MD number
Default setting: 0
Changes effective after Power On
Data type: BYTE
Meaning:
18800
MD number
Default setting: 0
Changes effective after Power On
Datentype: DWORD
Meaning:
This MD cannot SINUMERIK 802D sl.
© SIEMENS AG 2007 All rights reserved
SINUMERIK 802D sl/840D sl840D/840Di sl/840Di/810D ISO Turning - - 04.07 Edition
EXTERN_TOOLPROG_MODE
Tool change programming with external programming language
Minimum input limit: 0
Protection level: 2/7
Configuration of tool change programming for external programming language:
Bit0 = 0: Effective only with $MN_MM_EXTERN_CNC_LANGUAGE =2:
The tool number and offset number are programmed in the T value.
$MN_DIGITS_TOOLNO determines the number of leading digits representing
the tool number.
Example:
$MN_DIGITS_TOOL_NO = 2
T=1234 ; tool no. 12,
; offset no. 34
Bit0 = 1: Effective only with $MN_MM_EXTERN_CNC_LANGUAGE =2:
Only the tool number is programmed in the T value.
Offset number = tool number.
$MN_DIGITS_TOOL_NO is irrelevant.
Example:
T=12 ; tool no. 12
; offset no. 12
Bit1 = 0: Effective only with $MN_MM_EXTERN_CNC_LANGUAGE =2:
If the number of digits programmed in the T value is equal to the
number in $MN_EXTERN_DIGITS_TOOL_NO, leading zeroes are added.
Bit1 = 1: Effective only with $MN_MM_EXTERN_CNC_LANGUAGE =2:
If the number of digits programmed in the T value is equal to the number of digits
specified in $MN_EXTERN_DIGITS_TOOL_NO,
the programmed number is used as the offset number and the tool number
MM_EXTERN_LANGUAGE
External language active in the control
Minimum input limit: 0
Protection level: 2/7
This MD must be set to enable ISO Dialect0- -T and ISO Dialect0- -M programs to run on the
control. Only one external language can be selected at a time. Please refer to the latest
documentation for the available command range.
Bit 0 (LSB): Execution of part programs in ISO_2 or ISO_3 mode. For coding see
$MN_MM_EXTERN_CNC_SYSTEM (10880)
Machine and Setting Data
D.1 Machine/Setting Data
Maximum input limit: 1
Unit: - -
Applies with effect from SW version: 5.2
Maximum input limit: 1
Unit: - -
Applies with effect from SW version: 5
D-211