Table of Contents
Advertisement
Default for all zones is that they do not belong to any zone group.
Note: A zone can only be a member of one zone group. A validation error will occur if a
zone is programmed to be included in more than one zone group.
22.3.8
System information
In this dialog box you can read the following information:
This give all that has been programmed so far in the system. The information will be
updated when units etc. are added or deleted.
22.3.9
Edit Alarm texts
The user definable text message for each alarm point can be created / edited in the alarm
point dialog box respectively or via the menu: Systems | Edit Alarm texts. See Error!
Reference source not found., page Error! Bookmark not defined..
22.3.10
User data
To log on to the CIE. and/or the Web-server a User name and a password are required.
Ten different User names and corresponding passwords can be defined for three different
User levels (Information only, Building officer & Service personnel).
User level Information only gives access to the menus H4, H6
Level 2A)
User level Building officer gives access to the menus H1 – H4, H6, H7, H9 and H10.
(Access Level 2B).
User level Service personnel gives access to the menus H1 - H10. (Access Level 3A).
For more information regarding user names, passwords, user levels, logon to a Control
Unit, etc. see FT1020G3 Operation Manual.
157
The faults cannot be acknowledged on this level.
Technical/Programming Manual
159
FT1020G3 Rev 2.2.1
157
H9 and H10. (Access
Advertisement
Table of Contents
