Table of Contents
Advertisement
Switch
Turns Quick Scan OFF.
Used to adjust image quality automatically and perform
automatic compensation for the reception focus
simultaneously.
Used to select the 2D image size. [General] or [Large]
can be selected.
Adjusts the image quality of the zoomed image.
Optimizes the focal position automatically.
Used to display the needle mark (for details, refer to section
18 "Needle Mark").
Used to select the type of THI mode for 2D images. After
pressing this switch, use the corresponding knob to select
the mode from among [Fund], [PS], [Filter], and [Diff].
Used to adjust the scan range for the 2D image.
Used to adjust the color of the images.
Used to adjust the gamma curve.
Used to adjust the dynamic range.
Used to select the needle mark size.
*2
Used to adjust the sensitivity for the deeper areas and
frame rate.
Used to adjust the gain in the lateral direction of the image.
Steers the 2D image left and right.
(For scanning with a convex or sector transducer, this
*3
function is effective only when the viewing angle is limited
using the [Scan Range] function.)
Used to move the focus position.
Used to select the frequency for the 2D image. Generally,
a higher frequency is used to acquire images with higher
resolution, while a lower frequency used to increase
penetration in order to image deeper regions.
No. 2B771-004EN*M
Function
14-6
Advertisement
Table of Contents
