Table of Contents
Advertisement
7. Preparation for Examination
7.1
Moving and Installing the System
WARNING:
CAUTION:
CAUTION: 1. To prevent system malfunction, be sure to perform the following
2. Except in emergencies, do not attempt to stop system movement by
1. Use the system only on a level floor. Do not place the
system at a location where the slope is 5° or more. Doing
so may result in the system falling over and causing an
injury.
2. Do not push the system from the side. If the system is
pushed from the side, it may fall down and cause injury.
3. When the system is moved over a sloped surface, it must
be moved slowly by two persons. Otherwise, the system
may slide unexpectedly and cause a serious injury.
4. When the system is moved over a step, be careful not to
allow the system to fall. When holding the system at the
bottom to help move it over a step, take special care to
prevent hand injuries.
1. Lock the casters once the system is moved to its installation
location. Otherwise, the system may move unexpectedly,
injuring the patient or the operator.
2. Before moving the system, lock all movable sections, such
as the LCD monitor main panel. Otherwise, parts may move
unexpectedly, causing injury.
3. Before moving the system, confirm that all peripheral
devices are secured. If a peripheral device is not secured, it
may fall, causing injury or damage.
4. When a reference signal cable is used, disconnect it before
moving the system. Otherwise, the cable might catch the
feet or the casters, causing injury or damage.
operations before moving the system.
(a) Turn OFF the power and also turn OFF the main power switch on
the power panel.
(b) Stow the transducer in the transducer holder and hang the cables
on the transducer cable hanger.
(c) Move the system using the handle. Do not attempt to move the
system by pushing the panel or any part other than the handle.
engaging the caster locks. Doing so may damage the casters.
No. 2B771-004EN*M
7-1
Advertisement
Table of Contents
