Recovery From The Standby Status - Toshiba Aplio 500 TUS-A500 Operation Manual

NOTE: 5. Do not connect a USB device such as a flash drive to any of the external
USB connectors (the system is provided with five USB connectors) when
the system is in the Standby status. Doing so may result in the system not
starting up normally from the Standby status.

9.4.2 Recovery from the Standby status

CAUTION: 1. Do not disconnect the power plug from the outlet while the system is
2. If either of the following phenomena occurs, press and hold down
NOTE: 1. When resuming the system from pause status, confirm that the
[STANDBY] LED is blinking and then press
2. Do not operate the operation panel switches or keyboard while the system
is recovering from Standby status. The system may not start up normally.
3. Normally, the ultrasound image is displayed approximately 1 or 2 minutes
after the power switch is pressed in the standby status; however, the actual
time required varies depending on the system status.
resuming after being paused. The system may malfunction.
for 5 seconds or more to turn OFF the power of the system.
 The startup screen is not displayed after waiting for 30 seconds.
 The patient registration screen is not displayed after waiting for
10 minutes.
If the power is not turned ON after holding down
more, turn OFF the main power on the power panel.
Do not turn OFF the power in this manner during normal operation.
Doing so may cause the system to malfunction.
No. 2B771-004EN*M
9-11
for 5 seconds or
.