Restore System - ABB IndustrialIT Compact HMI 800 Getting Started

Backup and Restore of Configuration Data
3. Select the tab Summary and Start Backup.
4. To start the backup press the button Start Backup.
5. Press OK to start the backup, and then a popup window shows the progress of
the backup.
6. When the backup is finished close the window.

Restore System

To restore the system go through the following steps.
1. Open the Configuration Wizard and select Restore System and click Next.
2. If the backup shows up in the window go to step 22. If the backup does not
show up in the window, click Select Path, and add, and then browse to the
folder shown below.
Figure 72. Backup Folder
3. Click OK and OK again.
4. Select the backup that was done in step 2, and press Next. (If the change of
Computer Name has been done before the system has been configured, use the
restore dump available on the DVD supplied in the Compact HMI 800 delivery
(another path needs to be added)).
118
Section 7 Administration
3BSE040587R4401