Oiling The Blades; Operation; Changing The Attachments; Setting The Trim Length - Silvercrest 284982 Operation And Safety Notes

Note: When fully charged the product can be
used for up to 60 minutes of cordless operation.
Note: When the battery is almost empty, the
charging display on the display will flash. The
9
product can then only be used for a short period
of time before it will need to be connected to a
power supply.
Operating using the power adapter
If the product stops working during use due to an
empty or low battery, simply plug in the power
adapter to continue.
Insert the cable plug of the power adapter
into the bottom of the product.
To avoid injuries and damage to the product,
always switch the product off before charging.
Insert the power adapter
which meets the product specifications.
After a few seconds you can switch on the
product by sliding the ON / OFF switch
into the desired position for the desired speed.
If the product does not start working immedi-
ately, switch it off by sliding the ON / OFF
switch to the "0" position and wait 1 min-
3
ute before you try to switch it on again.

Oiling the blades

For good performance we recommend oiling the
blades before using the product for the first time
and after cleaning.
Apply one or two drops of blade oil
tween the blades and spread evenly.
Wipe off any excess oil with a cloth.
You can use any acid-free oil, e.g. sewing
machine oil.
7
into an outlet
7
3
be-
14
Note: The blade can be oiled with or without
comb attachment or thinning attachment

Operation

Changing the attachments

Carefully place the desired comb attachment
onto the product as shown. Ensure that
11
both recesses of the comb attachment
properly engage into the lateral detents at
both sides above the cutting unit
To remove the comb attachment
slide it forward and upwards using both
thumbs as shown.

Setting the trim length

To set different trim lengths, hold the upper part
of the product and twist the lower part of
2
the product into the desired position
5
(1/3₂ in–5/6₄ in / 0.8–2.0 mm). The set trim
length will be displayed on the length position
indicator which aligns with the dot-marking
4
on the upper part of the product
11
.
1
, press and
11
.
2
US-EN 13