NEC Express 5800 Series Installation Manual page 40

Hide thumbs Also See for Express 5800 Series:

Table of Contents

Chapter 1 Installing OS

- Follow the steps below when enabling an SSH connection to the ESXi host.

Select [Troubleshooting Options] and press Enter.

Select [Enable SSH] and press Enter to change the setting from [SSH is Disabled] to [SSH is

Enabled].

Press ESC to return to the [System Customization] menu.

Press ESC to log out.

Important

Do not change the network configuration that is created at installation of the ESXi

host before the setup procedure described in this guide completes.

If you need to add standard switch, perform it after setup process completes.

Note

Set [Configuration Management Network] and [Troubleshooting Options] according to your

environment.

Tips

If IPv6 is disabled in Configure Management Network, the system reboots automatically.

(Reboot confirmation message will not appear.)

Express5800/R320d-E4, R320d-M4 Installation Guide (VMware 5.5)

1. Setup Procedure

Table of Contents