Procedures After Completion Of Installation; Confirmation Of The Kernel Version - NEC Express 5800 Series Installation Manual

Chapter 1 Installing OS
2.

Procedures after Completion of Installation

2.1

Confirmation of the Kernel Version

Explain how to check the kernel version of ftSys Management Appliance and a version of VMware ESXi.
Check the version following the steps below.
VMware ESXi
1. Run the following command on the ftSys Management Appliance.
# esxcli –s <IP address of ESXi host> system version get
Product: VMware ESXi
Version: 5.5.0
Build: Releasebuild-1746018
Update: 1
Make sure that Version, Build, and Update are exactly same as those shown above.
ftSys Management Appliance
1. Run the following command on the ftSys Management Appliance.
# uname –a
Linux ftsysMgt-Cygnus 2.6.18-274.el5 #1 SMP Fri Jul 22
04:43:29 EDT 2011 x86_64 x86_64 x86_64 GNU/Linux
"2.6.18-274.e15" indicates version of kernel, and "#1 SMP Fri Jul 22 04:43:29 EDT 2011" indicates
release information of kernel.
Make sure that the version of kernel is correct.
This completes version confirmation.
Note The "Build" column shows the number given after the patch program was applied.
Express5800/R320d-E4, R320d-M4 Installation Guide (VMware 5.5)
2. Procedures after Completion of Installation
63