NEC Express 5800 Series Installation Manual page 50

Chapter 1 Installing OS
11. When the reboot confirmation message appears at the end of the installation, press y. Confirm that
the ESXi host is shutdown, and then, remove the ft control software Install DVD.
A host reboot is required to place these updates into service.
Do you want to reboot now [Y/n]: _
12. The syst em reboots, and the ft module registration and disk duplication are performed. These
processes take several tens of minutes.
13. After the system reboot, confirm that the System FT LED at the front of the server lights.
50
Note A message indicating a runtime error occurred on vSphere Client may be displayed when
ESXi host is rebooted.
<Example of error message>
Even if this message is displayed, you can ignore this message. ft control software has
been installed successfully at the time this message is displayed.
Note The time required for completing the duplication varies depending on the disk space.
Note The system will reboot twice if ft control software is installed in internal hard disk drive.
•
Tips When installing ft control software to an internal disk, the PRIMARY LED of the CPU/IO
module switches from #0 to #1. However, there is no problem continuing with the
setup.
When installing ft control software to an external storage, switching of the PRIMARY
LED of the CPU/IO module does not occur.
•
If the ft control software is installed in internal disk, the storage name of internal disk
(datastore1) is changed to datastore2 after the system restart. However, it does not
affect the system operation.
Express5800/R320d-E4, R320d-M4 Installation Guide (VMware 5.5)
1. Setup Procedure
System FT LED