Table of Contents
Advertisement
1-3. Replacing CCD Unit
1-3-2. Replacing CCD Unit
c
Never remove or install the CCD unit with the power turned on. Because touching internal harness to the
cabinet or other printed circuit boards during replacement causes shorts or electric hazards.
Prior to replacement, be sure to disconnect the optical cable or the cable connected at the DC IN connec-
tor in addition to turning off the power switch.
1. Open the right and left side panels.
2. Loosen the two screws and disconnect the connector.
Screws
Filter disk unit
3. Disconnect the flexible card wire.
n
Refer to Section 1-3-3 before disconnecting or connecting the flexible card wire.
1-2 (E)
Connector
Flexible card wire
HKC-7080
Advertisement
Table of Contents
