Table of Contents
Advertisement
Adjustment Procedures
1. Adjust the white balance.
WHITE button/MSU-700 → ON (lit)
2. Set the waveform monitor as follows.
.
LUM mode
VOLTFULL SCALE range → 0.5
.
3. R button/rear panel → ON
4. If the shading is monitored, proceed as follows
MSU menu operation:
. MAINTENANCE button → ON (lit)
. Touch panel operation
[Adjusting] → [White|Shading] → [R]
. Adjustment Items: H Saw, H Para, V Saw, V Para
(H SAW)
(V SAW)
5. R button/rear panel → OFF
G button/rear panel → ON
Adjust for G-ch in the same manner.
6. G button/rear panel → OFF
B button/rear panel → ON
Adjust for B-ch in the same manner.
7. Adjust the white balance.
WHITE button/MSU-700 → ON (lit)
Lens File Store
MSU menu operation:
. FILE button → ON (lit)
. Touch panel operation
[Lens|File] → [Lens|Store] → [Store]
HKC-7080
(H PARA)
(V PARA)
Adjustment for Lens Extender/Shrinker
When using the lens extender or lens shrinker, perform the
following adjustments after the completion of lens file
store.
8. (Using the lens extender)
Set the setup menu as follows.
MENU: Operation
PAGE: Battery/D56
ITEM: Lens File
(Select the file in accordance with the lens attached. If
there is no appropriate file, select NO OFFSET, then
change the name of lens with MSU.)
9. Lens extender (x2) → ON
10. Repeat procedures 3 to 7, then perform the lens file
store again.
11. Lens extender (x2) → OFF
12. (Using the lens shrinker)
Set the setup menu as follows.
MENU: Operation
PAGE: Battery/D56
ITEM: Lens File
(Select the file in accordance with the lens attached. If
there is no appropriate file, select NO OFFSET, then
change the name of lens with MSU.)
13. Lens shrinker (x0.8) → ON
14. Repeat procedures 3 to 7, then perform the lens file
store again.
15. Lens shrinker (x0.8) → OFF
Resetting after Adjustment
. R/G/B button/rear panel → OFF
2-3. White Shading Adjustment
2-3 (E)
Advertisement
Table of Contents
