Connection On The Device - ABB PositionMaster EDP300 Commissioning Instruction

6.4.4

Connection on the device

1 2
Fig. 21: Connection on device (example)
1 Blind plug 2 Cable gland 3 Terminals for options modules
4 Terminals attachment set for digital feedback 5 Terminals basic device
Change from one to two columns
For the cable entry in the housing, there are two tap holes
1/2 - 14 NPT or M20 x 1.5 on the left-hand side of the
housing. One of these holes has a cable gland and the other
has a blind plug.
NOTICE
The connecting terminals are delivered closed and must be
unscrewed before inserting the wire.
1. Strip the wires to approximately 6 mm (0.24 inch).
2. Connect the wires to the connecting terminals in line with
the connection diagram.
Wire cross-sectional areas
Basic device
Electrical connections
4 ... 20 mA input
Options
cross section
Rigid / flexible wires
Flexible with wire end
sleeve
Flexible with wire end
sleeve no plastic sleeve
Flexible with wire end
sleeve with plastic sleeve
Change from two to one column
2
Screw terminals max. 2.5 mm
2
Screw terminals max. 1.0 mm
2
0.14 ... 2.5 mm (AWG 26 ... AWG 14)
2
0.25 ... 2.5 mm (AWG 23 ... AWG 14)
2
0.25 ... 1.5 mm (AWG 23 ... AWG 17)
2
0.14 ... 0.75 mm (AWG 26 ... AWG 20)
3
M 20 mm /
NPT 1/2"
Multi-wire connection capacity (two wire with the same cross-
section)
Rigid / flexible wires
Flexible with wire end
sleeve no plastic sleeve
Flexible with wire end
sleeve with plastic sleeve
Option modules
Cross section
Rigid / flexible wires
Flexible with wire end
sleeve no plastic sleeve
Flexible with wire end
sleeve with plastic sleeve
Multi-wire connection capacity (two wire with the same cross-
(AWG 14)
section)
(AWG 18)
Rigid / flexible wires
Flexible with wire end
sleeve no plastic sleeve
Flexible with wire end
sleeve with plastic sleeve
Limit switch with proximity switches or 24 V microswitches
Rigid wire
Flexible wire
Flexible with wire end
sleeve no plastic sleeve
Flexible with wire end
sleeve with plastic sleeve
2
0.14 ... 0.75 mm (AWG 26 ... AWG 20)
2
0.25 ... 0.75 mm (AWG 23 ... AWG 20)
2
0.5 ... 1.5 mm (AWG 21 ... AWG 17)
2
0.14 ... 1.5 mm (AWG 26 ... AWG 17)
2
0.25 ... 1.5 mm (AWG 23 ... AWG 17)
2
0.25 ... 1.5 mm (AWG 23 ... AWG 17)
2
0.14 ... 0.75 mm (AWG 26 ... AWG 20)
2
0.25 ... 0.5 mm (AWG 23 ... AWG 22)
2
0.5 ... 1 mm (AWG 21 ... AWG 18)
2
0.14 ... 1.5 mm (AWG 26 ... AWG 17)
2
0.14 .... 1.0 mm (AWG 26 ... AWG 18)
2
0.25 ... 0.5 mm (AWG 23 ... AWG 22)
2
0.25 ... 0.5 mm (AWG 23 ... AWG 22)
PositionMaster EDP300 | CI/EDP300-EN Rev. C 21
4
5
M10950