10.2 Housing
Material / Degree of protection
Aluminum with
≤ 0.1% copper
Degree of protection
Surface / color (aluminum housing only)
Dipping varnish
Housing varnished black
Weight
Aluminum
Stainless steel 1.4404
(316L)
10.2.1 Mounting orientation
Any
10.3 Transmission data and influences
Output Y1
Increasing set point signal
Decreasing set point signal
Action (set point signal)
Increasing set point
Decreasing set point
Characteristic curve (actuator travel = f {set point signal})
Linear
Deviation
Configurable zone
Configurable dead zone
Resolution (AD-conversion)
Sampling frequency
Ambient temperature effect
Influence of vibration
1) Freely configurable with 20 reference points
Change from two to one column
32 CI/EDP300-EN Rev. C | PositionMaster EDP300
Optional stainless steel 1.4404 (316L)
IP 65 / NEMA 4X (NEMA 4X does not
permit overhead mounting)
With epoxy resin, stove-hardened
RAL 9005
RAL 9002
2.4 kg (5.29 lb)
5.5 kg (12.13 lb)
0 ... 100 %
Increasing pressure at output
0 ... 100 %
Decreasing pressure at output
4 ... 20 mA
= actuator position 0 ... 100 %
20 ... 4 mA
= actuator position 0 ... 100 %
Equal percentage 1:25 or 1:50 or 25:1 or
1)
50:1
< 0.5 %
0 ... 100 %
0.1 ... 10 %
> 16,000 steps
20 ms
< 0.5 % for each 10 K
< 1 % to 10 g and 80 Hz
10.3.1 Seismic vibration
Meets requirements of DIN / IEC 60068-3-3 Class III for strong
and strongest earthquakes.
10.3.2 Influence of mounting orientation
Not measurable.
10.3.3 Noise emissions
Max. 100 db (A)
Noise-reduced version max. 85 db (A)
10.4 Ambient conditions
Ambient temperature range
During operation, storage,
and transport
1) Increased temperature range only with EDP300 Remote Sensor.
Relative humidity
During operation with
housing closed and air
supply switched on
Transport and storage
11 Additional documents
NOTICE
All documentation, declarations of conformity, and certificates
are available in ABB's download area.
www.abb.com/positioners
Trademarks
® HART is a registered trademark of FieldComm Group, Austin, Texas,
USA
-40 ... 85 °C (-40 ... 185 °F)
-40 ... 100 °C (-40 ... 212 °F)
1)
95 % (annual average), condensation
permissible
75 % (annual average)