Menu Levels - ABB PositionMaster EDP300 Commissioning Instruction

Change from two to one column
8.3

Menu levels

There are two levels under the process display.
Information level
Diagnosis
Operator Page 1
Signals View
Change from one to two columns
Process The process display shows the current process values.
display
Information The information level contains the parameters and
level information that are relevant for the operator. The device
configuration cannot be changed on this level.
Operating In the operating modes menu, the Auto Adjust function
modes menu can be started for commissioning purposes. You can
also change the operating modes and switch to the
configuration level.
Configuration The configuration-, parameterization instruction contains
level all the parameters required for device commissioning
and configuration. The device configuration can be
changed on this level.
NOTICE
Property damage
During external configuration via a PC, the positioner no
longer responds to the set point current. This may lead to
process failures. Prior to external configuration, always move
the actuator to the safety position and activate manual
adjustment.
NOTICE
For detailed information on the parameterization of the
device, consult the associated operating instructions and
configuration and parameterization instructions.
30 CI/EDP300-EN Rev. C | PositionMaster EDP300
Process display
Operating modes menu
Auto Adjust
Adaptive
Control
Manual SP
Manual Sensor
Configuration
Configuration level
Easy Setup
Device Setup
Display
Control
Input/Output
Communication
Diagnosis
Device Info
Service