Menu Levels - ABB PositionMaster EDP300 Operating Instruction

40 PositionMaster EDP300 DIGITAL POSITIONER | OI/EDP300-EN REV. D
... 9 Operation

Menu levels

There are three menu levels below the process display.
Diagnosis
Operator Page 1
Signals View
Change from one to two columns
Process display
The process display shows the current process values.
Information level
The information level contains the parameters and information
that are relevant for the operator. The device configuration
cannot be changed on this level.
Operating modes menu
In the operating modes menu, the Auto Adjust function can be
started for commissioning purposes. You can also change the
operating modes and switch to the configuration level.
Configuration level
The configuration-, parameterization instruction contains all the
parameters required for device commissioning and
configuration. The device configuration can be changed on this
level.
Information level
Process display
Operating mode
Auto Adjust
Adaptive
Control
Manual SP
Manual Sensor
Configuration
Easy Setup
Device Setup
Display
Control
Input/Output
Communication
Diagnosis
Device Info
Service
NOTICE
Property damage
During external configuration via a PC, the positioner no
longer responds to the set point current. This may lead to
process failures.
• Before any external parameterization, always move the
actuator to the safety position and activate manual
adjustment.
Note
For a detailed description of the individual parameters and
menus on the configuration level, please refer to Parameter
descriptions on page 50.
Configuration