Front Panel - Panasonic YD-350GL4 Operating Instructions Manual

5.2 Front panel
○
1
○
2
○
3
○
8
○
4
NO. name
temperature
○
1
abnomal indicator
current display
○
2
7-segment LED
setting
" current "
" wire feeding
speed "
○
3
" plate thickness "
" spot welding
time "
function select
Names and functions
○
5
○
9
○
11
○
7
● When abnormal rise in important components temperature occurs,
temperature abnomal alarm is sent, this lamp blinks and the welding
operation stops. Welding operation cannot be restarted unless this lamp is
turned off. ( For troubleshooting:
When Mode selection key ○
・On stand-by status,, it shows the current value set in ○
・During welding, it shows the current value of the actual output.
● When Mode selection key ○
・ It shows fine adjusting setting items PXX(XX stands for 00->29), default
display CH-OFF( voltage display LED○
● When Mode selection key ○
・The default display CH-OFF. By turning the Jog-dial ○
number, LED shows "CH" channel. If welding parameters are available,
the channel can be selected, else the corresponding channel can NOT be
selected. When the channel stored with data is selected, the channel and
parameters are displayed alternately and welding can start.
● When Mode selection key ○
・By turning the Jog-dial ○
"CH" setting current and voltage. Flashing means welding parameters are
being stored.
・Press selection key ○
corresponding parameters are recorded in the channel being selected.
● When a self-diagnosable error occurs, ( For troubleshooting:
Section 13.1)
・ it shows Err( voltage display LED○
● When " current " / " wire feeding speed " function is selected, the
setting method of the corrosponding selection number is decided by P11
of "F. Adj" function menu. When P11 is 0, it is adjusted by wire feeder
potentiometer; when P11 is 1, it can be changed by Jog-dial ○ 4 . Note
" plate thickness " can be displayed only instead of being changed.
●" spot welding time " function is adjusted by Jog-dial ○ 4 .
Note To change" spot welding time ", welding control ○ 13 is to be
selected as " spot welding " function.
○
6
○ ○
12 13
○
10
○
○
15
16
description
Section 13.1).
is set to" Weld "
12
is set to"F. Adj" (
12
shows its specific set value ).
5
is set to " Call " (
12
is set to " Record " (
12
, channel number can be selected. LED shows
7
to return to " Weld " from " Record " and the
12
shows alarm signal number ).
3
12
○
18
○
14
○
19
○
17
3
Section 5.4)
Section 5.6)
, select channel
7
Section 5.6)