Panasonic YD-350GL4 Operating Instructions Manual page 2

■ Caution for your safety
Read and understand this manual before installing,
operating or servicing this product.
The wiring and grounding should be done by
educated and/or skilled person.
■ Cautions about electromagnetic disturbance
● Extra precaution may be required when welding
power source is used in a domestic establishment.
● Before installing welding equipment ,the user shall
make an assessment of potential
Electromagnetic problems in the surrounding area
as below.
a) Other supply cables, control cables, signaling
and telephone cables; above, below and
adjacent to the welding equipment;
b) Radio and television transmitters and receivers;
c) Computer and other control equipment;
d) Safety critical equipment , e.g. guarding of
industrial equipment;
e) The health of the people around , e.g. the use of
the pacemaker and hearing aids;
f) Equipment used for calibration or measurement;
g) The immunity of other equipment in the
environment; the user shall ensure that other
equipment being used in the environment is
compatible ;this may require additional
protection measures;
h) The time of day that welding or other activities
are to be carried out.
■
Exporting the machine into the EU
This product does not meet the requirements specified in
the EC Directives which are the EU safety ordinance.
Please bear in mind that this product may not be brought
as is into the EU. The same restriction also applies to any
country which has singed the EEA accord. Please be
This equipment and instructions are for use only by
persons trained and experienced in the safety
operation of welding equipment. Do not allow
untrained persons to install, operate, or maintain this
equipment.
● The user shall be observe to reduce emission
disturbance as below.
a) Welding equipment should be connected to
mains supply according to the manufacture's
recommendations.
b) Welding equipment should be routinely
maintained according to the manufacture's
recommendations.
c) The welding cables should be kept as short as
possible and should be positioned close
together, running at or close to the floor level.
d) Confirm to connection of all metallic component
in the welding installation and adjacent to it
should be considered for safety.
e) The work-piece should be connected to earth
for electric safety.
f) Selective screening and shielding of other
cables and equipment in the surrounding area
may alleviate problems of interference.
Screening of entire welding installation may be
considered for special applications.
absolutely sure to consult with us before attempting to
relocate or resell this product to or in any EU member
state or any other country which has signed the EEA
accord.