6.14
Connecting grounding wire
CAUTION
1
Ground terminal
2
Grounding wire
3
Ground
* Grounding work should be performed by qualified elec-
tricians.
6.15
Connecting input power cable
WARNING
1
Turn off power at the distribution box.
(
)
2
Remove the terminal cover
(
)
3
Connect one end of input power cable to the input
(
)
terminal.(Phase order does not matter.)
Note
Do not use wrench
Tightening torque:2.45
Nm
4
Reinstall the terminal cover.
(
)
5
Connect the other end of the input power cable to the
(
)
load-side terminal of the switch of the distribution
box.
(For reference)
Input power cable size: 10 mm
Connection
Water supply pipes, building iron frames, etc. do not serve as sufficient ground.
Do not connect any grounding wire to them.
M8 bolt
2
10 mm
or more.
Customer preparation
-
• Install one distribution box each for this product.
• Make sure to turn off the power distribution box first.
- 3.40
Nm
2
or more
18
1
2
3
1
2
-
1
Distribution box
2
Input power cable
3
Input terminal board
4
Terminal cover
4
A
3
Customer preparation
Customer preparation
-
-