Panasonic YD-350GL4 Operating Instructions Manual page 28

【INIT·CRATER】
NO. Menu contents
CRATER
P06
REPEAT
CRATER
P07 REPEAT
TIME
Crater linkage
P14
percentage
INIT linkage
P13
percentage
INIT·CRATER
P27
Switch
【Others】
NO. Menu contents
P24 Arc shape
Welding display
P25
mode
P28
Deepen test
welding
P29
function
※ 6
enabled
※6 P29 (Deepen Trial function enabled)
When the accumulated welding time reaches 3 hours after the timer for trial starts, this function is
disabled. If you desire to continue, please contact with distributor to activated this function.
Settings
Set range Increment
0 or 1 1
0 s～5 s 1 s
0～200 1
0～200 1
0 or 1 1
Set range Increment
-99～99 1
0 or 1 1
0 or 1 1
24
Default
1: enabled, 0: disabled.
0
（
Chapter 8）
The setting of the value of the time of
2 s
closing arc repeating.
NOT 0: The arc current is [Welding
current] * [Setting value] %; 0: The closing
arc current is the setting of [Arc current
value].
0
Note: After the linkage percentage is set,
the arc current does not exceed the
maximum welding current limit [350 A /
500 A]
Not0: Initial current is [Welding current] *
[Setting value] %;
0: Initial current is the set [Initial current
value].
0
Note: After the linkage percentage is set,
the initial current will not exceed the
maximum value of the welding current [350
A / 500 A]
0 1：AUTO
Default
The higher value you set, the more
0 concentrated arc you get；The
lower, the less concentrated arc.
0 stands for current and voltage
0 display ;1 stands for energy
display [P=U*I]
1: enabled, 0: disabled.
0 Test welding can last for 3 hours
Deepen function
Note
0：Manual
Note
reserved for