Panasonic YD-350GL4 Operating Instructions Manual page 26

NO. Menu contents
P20 FTT Voltage
BURNBACK
P21
※
3
TIME 1
BURNBACK
P22
※
3
TIME 2
※1 P00（SLOW DOWN）
To obtain solid arc start, set the wire feed speed immediately after turning on the torch switch
slower than that in normal welding operation.
※2 P12（ Loop resistance Compute
When using or replacing a cable for the first time, you need to calculate the loop resistance
※3 P21 和 P22（BURNBACK TIME 1 and BURNBACK TIME 2）
It is the duration of time (short period of time) to keep supplying output voltage after stopping the
arc by turning off the torch switch. (It is to burn up excess wire fed out of the end of the torch tip
due to inertia of the wire
【Pulse-OFF】
【 Special purpose machine and Robot 】
NO. Menu contents
Wire
adhesion
P09
detection
ON/OFF
Given current
P23 and voltage
setting
Robot
P26 connection
※
4
mode
Settings
Set range Increment
-50～50 1
-50～50 1
-50～50 1
）
feed motor.
Set range Increment
0 or 1 1
0、1 or 2 1
0 or 1 1
22
Default
Fine adjustment of output voltage during
burn-back time. (The setting reflects on the
0 wire burning at arc end.)
Increase the set value for stronger wire
burning.
【Pulse-OFF】The time of the main welding
voltage to the back burning voltage,
0 Under normal circumstances, users do not need
to adjust.
【Pulse -ON】Peak pulse current time.
【Pulse-OFF】 Burning back the role of voltage
0 time, the user to adjust the P22
【Pulse-ON】Number of burn back pulse.
P21
【Pulse-ON】
P22
Default
When the Product works with
machine or robot, the setting can be used.
When welding finishes or starts,
0
between welding wire and base metal can be
detected automatically.
Input signal voltage setting corresponding to
the maximum output
0 (when using a signal other than the remote
controller):
0: 15V input 1: 12V input 2: 10V input
1: Compatible mode ("external terminal board
0 1" interface multiplexing);
0: Normal mode.
Note
Note
special purpose
the adhesion