Placing An Sdcc In Service - Fujitsu FLM 150 ADM Maintenance And Trouble Clearing

Maintenance and Trouble Clearing
FJTU-320-515-480
5.7

Placing an SDCC In Service

5.7.1 Overview
This procedure lists the steps required to place the Section Data Communications
Channel (SDCC) in service.
This task can be performed using FLEXR or TL1.
Note: The EDIT-SDCC command only provisions the channel. The INIT-SDCC command is
required to make it active.
5.7.2 FLEXR Procedure
Retrieve the SDCC status.
Step 1
a. From the Provisioning menu, choose Section DCC then choose SDCC
Service State. The Service State dialog box opens.
b. Select an Access ID.
c. Click Retrieve to show the current SDCC setting. The possible settings are
In Service or Out of Service. Is the channel in service?
Click Cancel to close the dialog box.
Call the Fujitsu Technical Assistance Center at
1-800-USE-FTAC (1-800-873-3822) for assistance.
Issue 9, May 1999
If Yes:
FNC and FNC Customer Use Only
5.7: Placing an SDCC In Service
If No:
Go to Step 2.
Vol. ll, Page 480.5-24