Table of Contents
Advertisement
[When using the ServerStart CD]
1.
Insert the "Hardware Configuration Tool Boot Floppy" in the floppy disk drive, and
turn on the server.
2.
Select "Basic (BIOS Environment Support Tools)" from the menu that is displayed,
and press the [Enter] key.
MS-DOS is started up.
3.
Insert Remote Service Board Utility provided with this product into the floppy disk
drive on the server unit.
4.
Enter the following command:
The SERVICE PROCESSOR TOOL is started up.
b:
sptool [Enter]
\
FUJITSU
SIEMENS
COMPUTERS
System Information (ID-PROM)
General Information
Error and Message Log
Fan Information
Temperature Information
Powersupply Information
Power / Reset Control
Voltage Information
CPU Information
Memory Module Information
PCI Bus Information
Alarm Settings (Pager / SMS / E-Mail)
VT100 Settings
Remote Manager Settings
Network / Serial Interface / Users / SNMP Settings
Server Management Control Settings
Storage Extension (SE / CAN-Bus) Settings
<↑↓> Select
5.
Select the desired item using the [↑] or [↓] key, and press the [Enter] key. This
displays the screen for the desired item.
SERVICE PROCESSOR TOOL - Vx.xx
[Copernicus II / RSB]
<Enter> Start
<ESC> Exit
↑ ↑ ↑ ↑
↓ ↓ ↓ ↓
17
E
Advertisement
Chapters
Table of Contents
