Siemens SINUMERIK 840D sl Commissioning Manual page 23

Drive paths
Use the syntax described in the table below for entering the drive paths.
Logical drive
//NC/MPF.DIR
//NCU_1/MPF.DIR
/SIEMENS/SINUMERIK/MPF.DIR/
/siemens/sinumerik/mpf.dir/
/card/user/data
C:/ MPF.DIR/
c:\mpf.dir
//tcu1/X204/mpf.DIR
//tcu1/X203,1/test/mpf.dir
//usb/X204/mpf.DIR
//ACTTCU/FRONT
//ACTTCU/FRONT,1
//ef3307/MPF.DIR
//ef3307/MPF.DIR
//NC/NC_CARD/MPF.DIR
//PLC/XXXXXXX
1. Example
You must make the following entries to display the content of the first partition of the USB
device connected to the front of the actual TCU:
[CONNECTIONS]
ConnectionNum=1
Connection1=//ACTTCU/FRONT,1
SK_Connection1=Front-USB
SoftkeyIndex1=3
SoftkeyTextContext1=SlPmLogicalDrives
SoftkeyTextFile1=slpmdialog
SoftkeyPicture1=sk_usb_front.png
AccessProgram1=7
AccessMachine1=7
AccessServices1=7
A new softkey then appears at position HSK3 (position 3 on the horizontal softkey bar) on
the user interface with the text "Front USB". The softkey also shows the icon
sk_usb_front.png an and is visible in the operating areas "Program", "Services" from access
level 7.
Commissioning HMI-Embedded (IM2)
Commissioning Manual, 01/2008, 6FC5397-8CP10-1BA0
2.3 Setting-up network connections
Current NC
Specific NC
Local drive on CF
External drives WinXP hard disk (Win version)
Global TCU-USB drive
-||- with partition data
Global NCU-USB drive
Local TCU-USB drive (=USB device on the active
TCU, also has a matching global path)
-||- with partition data
External network drives (WinXP)
External network drives (Linux)
CF Card via SSH
PLC
Configuring the HMI system
23