Series Start-Up; Introduction; Output Of Data - Siemens SINUMERIK 840D sl Commissioning Manual

Series start-up

6.1

Introduction

In order to transfer a particular configuration to further controls of the same software version
as simply as possible (e.g., those that are operated on the same machine type), you can
create what are called series startup files.
1. Series startup with or without compensation data
2. Area—specific archiving:
This type of file cannot be modified externally using an ASCII editor.
6.2

Output of data

Procedure
1. Select the "Services" operating area.
2. Press the "ETC" key.
3. Press the horizontal softkey "Series commissioning".
4. Use the arrow keys to select an area (.arc) and mark it with the "Select" key.
5. Start the "Output data" operation by pressing the "Generate Archive" softkey.
6. The lower part of the window contains the "Save as..." field and the drives that have been
7. Using the arrow keys, mark the storage location, e.g. "memory card (CF)" (CompactFlash
8. Press the "OK" softkey.
Commissioning HMI-Embedded (IM2)
Commissioning Manual, 01/2008, 6FC5397-8CP10-1BA0
– PLC data
– Drive data
A window opens in which you can make the following selection:
– NCK data – with compensation data
– Drive data
– PLC data
set-up are displayed as storage location.
card).
6
97