Transport And Storage; Safety; Transport Components Of The Motor-Pump Unit - Bosch Rexroth Sytronix FcP 50 Series Operating Instructions Manual

Motor-pump unit mpes2
Table of Contents

Advertisement

DOK-SYTROX-MPES2******-IT01-EN-P
Rexroth Sytronix FcP 50xx/70xx Motor-Pump Unit MPES2
6

Transport and Storage

6.1

Safety

6.2

Transport Components of the Motor-Pump Unit

LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
CAUTION
Assure the weight and the position of the gravity center of the
components of the FcP system Use suitable lifting tools and
forklift trucks for transport of the FcP systems.
Never walk under hanging loads. Ensure that non-partici‐
pants are not in the danger zone.
To fasten the means of transportation or to lift the products,
exclusively use prepared points and lifting means. Observe
the maximum load capacity of the lifting means and forklift
trucks.
Place the product on a suitable surface.
Use suitable protective equipment and protective clothing
during transport; wear safety shoes
Do not lift the motor on the shaft or on the optional fan hous‐
ing.
CAUTION
Always lift the motor-pump unit with lifting means and with suitable lifting
gears.
The components must be transported in their original package taking classes
2K2, 2B1, 2C2, 2S2, 2M1 specified acc. to DIN EN 60721-3-2 into account.
Please observe the following classification limitations:
Transport temperature range -20 ... +60 ℃
Relative air humidity max. 75% (at +30 °C)
No occurrence of salt mist
Observe the notes on transport on the packing.
Always keep the environmental conditions which are described in the
data sheets of the components
mentary Documentation" on page 15
Provide shock absorption if strong vibrations may occur during trans‐
port.
Close the packaging according to the delivery state if it must be opened
for control reasons.
Remove the protective plugs just before assembly, if possible.
Bosch Rexroth AG
Transport and Storage
Risk of injury, damage during transport
caused by tumbling, falling or uncontrolled
change of position of the FcP system compo‐
nents.
Danger due to overload or not suited poise of
body during lifting and transport!
Injuries and postural defects!
chapter 1.2 "Necessary and Supple‐
during storage and transport.
39/143

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rexroth sytronix fcp 70 series

Table of Contents